Table of Contents
Advertisement
Remove Filler Module
CAUTION
Do not operate the Chassis with empty slots. Install Filler modules in empty slots to
ensure proper airflow through the Chassis.
Mise en Garde
N'utilisez pas le châssis avec des fentes vides. Installez des modules de remplissage
dans les fentes vides afin d'assurer un écoulement d'air adéquat dans le châssis.
How to Remove Filler Module
1
Power down the Chassis to Standby Mode.
2
Loosen the Captive Screw on each side of the Filler Module. Loosen screws
completely before trying to remove a module.
3
Grasp the captive screws and pull to remove the module from the Chassis.
4
Store Filler Module for future use.
Install Module
NOTE
Some modules require specific hardware configurations and connections which are not
described in this document. Refer to the documentation included with each module for
special configuration instructions.
CAUTION
Modules are ESD sensitive and should only be installed, removed and/or serviced by
Qualified Service Personnel.
Mise en Garde
Les modules sont sensibles aux DES et ils doivent seulement être installés, enlevés ou
entretenus par du personnel de service qualifié.
Verify the following before beginning installation:
•
Slot does not contain foreign objects or debris.
•
Backplane pins are not bent or damaged.
Rev. D0
May 2020
mA-1302/mA-1305 AXIe Chassis Operation Manual
Chapter 3 mA-1302/mA-1305 Setup and Installation
Module Installation
Page 3-9
Advertisement
Table of Contents
