Changing The Assignment Of The Control Terminals X5 And X6; Free Configuration Of Digital Input Signals - Lenze 9300 Series System Manual

6.5

Changing the assignment of the control terminals X5 and X6

6.5.1

Free configuration of digital input signals

Description
Codes for parameter setting
Code Possible settings
No. Name Lenze Selection
C0114
1 DIGIN1 pol 0
2 DIGIN2 pol 0
3 DIGIN3 pol 0
4 DIGIN4 pol 1
5 DIGIN5 pol 0
5 DIGIN6 (ST) pol 0
EDSVF9383V EN 7.1−04/2012
Changing the assignment of the control terminals X5 and X6
Free configuration of digital input signals
}
Danger!
If you select a configuration in C0005, the signal assignment of
the inputs and outputs will be overwritten with the
corresponding basic assignment!
Adapt the signal assignment to your wiring!
ƒ
ƒ Internal digital signals can be freely linked with external digital signal
sources. This serves to establish a freely configurable control of the
drive controller.
– Digital inputs X5/E1 ... X5/E5
ƒ A signal source can be linked with several targets. Ensure reasonable
linkages for not activating functions that are mutually exclusive (e. g.
linking a digital input with quick stop and DC injection braking at the
same time).
0 High active HIGH level is
active
1 LOW active LOW level is active
l
IMPORTANT
Inversion of digital input signals at
X5, function block DIGIN
Terminal X5/E1
Terminal X5/E2
Terminal X5/E3
Terminal X5/E4
Terminal X5/E5
Terminal X5/ST
6.5
6.5.1
^
6.5−1
See System
Manual
(extension)
6.5−1