Drilling The Holes Into The Mounting Plate - Lenze 9300 Series System Manual

4 Installing of the standard device
4.2 Basic devices in the power range 110 ... 200 kW
4.2.2

Drilling the holes into the mounting plate

4.2.2 Drilling the holes into the mounting plate
4.2−2
Assembly space
Left/right of other controllers
Left/right of a non−heat−conducting wall
Top/bottom
Comply with the clearances given to ensure a sufficient cooling of the
controller. When using an air lock, different clearances apply (see Mounting
Instructions for the air lock).
a1
a2
a3
b
d
a2
a1
Fig. 4.2−2 Bore holes in the mounting plate for fixing the controller
a1 a2
450 mm 340 mm
1. Mark the bore holes on the mounting plate according to the figure.
2. Drill the holes into the mounting plate.
l
Minimum clearance
30 mm
100 mm
200 mm
a3 b
225 mm 1005 mm
EDSVF9383V EN 7.1−04/2012
93vec048
d
9 mm (12x)