1 Connect the logic analyzer cable to the logic analyzer circuit board.
2 Secure the cable to the rear panel.
CAUTION:
Chapter 6: Replacing Assemblies
To install the logic analyzer cable
a Align the logic analyzer cable end connector with the circuit board
cable connector and gently apply pressure to seat the logic analyzer
cable onto the circuit board connector.
a Install the T10 screws (two per cable) and tighten to 5 in/lb.
If you over tighten the screws, damage to the rear panel may occur. Tighten the screws
only enough to hold the cable in place, approximately 5 in/lb.
86