Mounting Consumables - Intec CS4000 User Manual

Installing the Device
4
Hold the carrying levers while grasping
the carrying handles, and use at least 4
people to lift and carry simultaneously.
1
Note
Make sure not hold anywhere other than the
carrying handles, such as the paper feed trays or
side covers, etc. Doing so may cause injury due to
dropping the device.
Make sure to use 4 people min. for lifting and
carrying so there is no back pain, etc.
2
3
4
5
Gently lower the device into its
installation location.
Note
Gently and carefully lower the device. There is a
risk of crush injuries to hands, etc.

Mounting Consumables

 Setting the Toner Cartridge
1
Remove the toner cartridge from its
cover bag.
2
Shake the toner cartridge both
horizontally and vertically.
Note
Do not drop the toner cartridge or tap it on the
fl oor. Doing so may damage the cartridge.
3
Open the toner replacement cover.
4
Check the position of the slot that has a label stuck
on it with the same letters and colors, and fi rmly
push the toner cartridge in as far as it will go.
- 38 -
5
Close the toner replacement cover.
 Remove the image drum stopper
Memo
The image drum is set inside the device at the factory.
Reference
For the methods of replacing the image drum, see
"Troubleshooting/Daily Maintenance Manual", or the device
help.
The stopper is mounted to the image drum in
the device at the factory.
Make sure to use the following procedure to
remove the stopper before use.
1
Open the front cover.
Installing the Device
2
Gently raise the (blue) lever (
remove the image drum ( ) while
being careful not to touch the green
cylinder with your hands.
Note
Do not expose the image drum to direct sunshine
or strong light (approx. 1,500 lux or above). Do not
leave it for more than 5 minutes even under indoor
light.
Be careful not to touch or scratch the image drum
(green cylinder).
- 39 -
), and
1
2
3
4