Intec CS4000 User Manual page 15

Parts Nomenclature and Functions
 Standby Screen
There are two types: " Remaining toner quantity
display" and "Tray information display".
1
Use the following procedure to switch the
standby screens.
1
Press either the scroll button
on the control panel to display the
"Functions" screen.
2
3
2
Press the scroll button several times
to select the [Admin Setup], and then
press the [OK] button.
4
3
Use the 10-key pad to enter the
administrator password.
The default factory-set password is
"aaaaaa". Press the [OK] button after
entering each individual character.
4
Press the [OK] button.
5
Press the scroll button
to select [Panel Setup], and then press
the [OK] button.
or
6
Press the scroll button
to select the [Idle Display], and then
press the [OK] button.
7
To display the "remaining toner
quantity" in the standby screen, select
[Toner Gauge], and then press the [OK]
button.
To display the "tray information", select
[Paper Size], and then press the [OK]
button.
8
Press the [ON LINE] button to return to
the standby screen.
- 26 -
 Error Screen
several times
If a printer error occurs, the maintenance lamp
will either turn ON or fl ash, and a message will
be displayed in the liquid crystal panel.
Depending on the error, the error countermeasure
and animations may be displayed in the liquid
crystal panel in addition to the message.
Reference
 "Troubleshooting/Daily Maintenance Manual"
Press the control panel buttons in the error
screen to set the device to the following
statuses.
several times
[POWER SAVE] button:
The printer will enter power save mode. Press
the [POWER SAVE] button when the device is
in power save mode to return to the standby
screen.
[HELP] button:
Press the [HELP] button when it is lit to display
the relevant help message for the error that is
currently displayed.
[OK] Button:
In the case of errors for which the error message
vanishes when the [OK] button is pressed, the
printer will return to the standby screen.
[ON LINE] button:
In the case of errors for which the error message
vanishes when the [ON LINE] button is pressed,
the printer will return to the standby screen.
[CANCEL] button:
The following errors can be cancelled.
 MPTray Empty
 Change [MEDIA_SIZE] [MEDIA_TYPE] in
[TRAY]
 [TRAY] Empty
 Check Paper in [TRAY]
 Paper Size Error
 Change [MEDIA_SIZE] [MEDIA_TYPE] in
MPTray
 The print data size is too large to store it into
printer memory
 Toner Empty
 Multiple sheets of paper were fed at once
 Paper cassette is not in [TRAY]
 Feed print job manually
Parts Nomenclature and Functions
 Help Screen
Press the [HELP] button to display the help
screen. Further, press the [HELP] button when it
is lit to display the relevant help message for the
error that is currently displayed.
Press the scroll button displayed in the help
screen to scroll to the previous page. Press the
scroll button to scroll to the next page.
To close the help screen, press the [HELP] button
again.
Memo
 Press and hold either the scroll button or
through the pages at approx. 0.5-second intervals.
 The help screen can also be closed by pressing the [BACK]
button, [ON LINE] button, or [CANCEL] button.
- 27 -
1
2
3
to scroll
4