Turning Off The Power Supply; Test Printing Using The Printer Only - Intec CS4000 User Manual

Turning ON/OFF the Power
Turning OFF the Power
Supply
1
During normal use, use the following procedure
to turn OFF the power supply.
Note
Once shutdown has been implemented, it cannot be
stopped. To turn ON the device power supply again, wait
until shutdown has fi nished, and then turn ON the power
supply.
2
1
Press and hold the power switch for
approx. 1s.
3
4
"Shutting down. Please wait. Power
will turn OFF automatically" will be
displayed in the control panel, and the
power switch LED lamp will fl ash on an
approx. 1-s cycle.
Wait a moment, and the power
supply for the device will turn OFF
automatically, and the LED lamp on the
power switch will turn OFF.
Note
Press and hold the power switch for 5s min. to force-turn
OFF the power supply. Use only if a problem has occurred.
For device problems, see "Troubleshooting/Daily
Maintenance Manual".
In the following cases, use the following
procedure to turn OFF the main power supply.
If not using the device for long periods over
holidays or during travel, etc.
If mounting optional or maintenance products.
If moving the device.
If implementing device repairs or inspections,
etc.
1
Press and hold the power switch for
approx. 1s.
"Shutting down. Please wait. Power
will turn OFF automatically" will be
displayed in the control panel, and the
power switch LED lamp will fl ash on an
approx. 1-s cycle.
Wait a moment, and the device power
supply will turn OFF automatically, and
the LED lamp on the power switch will
turn OFF.
2
Turn the main power supply switch to
the OFF (O) position to turn OFF the
power supply.
- 52 -

Test Printing Using the Printer Only

Check that printing is actually enabled using the printer only. Check by printing the device setup and
setup details, which enable the status to be checked. ( Printer information.)
Memo
Print the "printer information" on A4 size paper. Set A4 size paper in the paper feed tray.
Reference
See "Turning ON the Power Supply" (P.51) for how to turn ON the power supply.
1
Set A4 paper in tray 1.
2
Check that the standby screen is
displayed in the liquid crystal panel.
3
Press the [Fn] key.
The numerical values input screen will
be displayed.
4
Press [1], [0], [0], and then press the
[OK] button.
5
When [Execute] has been selected,
press the [OK] button.
The printer information will be
displayed.
Test Printing Using the Printer Only
- 53 -
1
2
3
4