Turning On/Off The Power; Power Supply Precautions; Power Supply Conditions; Connecting Power Cables - Intec CS4000 User Manual

Turning ON/OFF the Power

Turning ON/OFF the Power
1

Power Supply Precautions

There is a risk of getting
WARNING an electric shock and/or
causing fire.
 Be sure to cut off the power supply when
attaching or removing the power supply plug
2
or the earth wire.
 Be sure to connect an earth wire to the
grounding terminal of exclusive use.
 Please do not connect with the ground of a
water pipe, a gas pipe, and a telephone wire,
or lightning rod without fail.
 Make sure to connect with the ground terminal
before connecting the power cord to the
3
power supply plug.
 Be sure to perform extraction and insertion of
the power cord with a power supply plug.
 Insert the power supply plug into the wall
socket securely.
 Do not touch the power cord, or machine, if
your hands are wet.
4
 Install the power cord in a location where it will
not be stepped on, and do not place objects on
the power cord.
 Do not twist, bind, or knot the power cord.
 Please do not use a damaged power cord.
 Do not carry out foot wiring.
 Do not connect this machine and other electric
products to the same wall socket. If connected
simultaneously with an air-conditioner, a copy
machine, shredder, etc., electric noise may
interfere with operation. When the connection
with the same wall socket is unavoidable,
please use a commercial noise fi lter or a
commercial noise cut transformer.
 Use the attached power cord and insert it
directory with the ground terminal. Do not use
power cords intended for other products with
this machine.
 Do not use an extension cord. When use is
unavoidable, use a cord rated higher than 15A.
 Use of an extended cord may cause AC
voltage decrease and interfere with normal
operation.
 During printing, do not shut off the power
supply or pull out the power supply plug.
 When not in use for consecutive holidays or
longterm travel, pull out the power cord.
 Do not use the attached power cord for other
products.

Power Supply Conditions

Observe the following power supply conditions.
Current: 110 - 127VAC
(Range 99 - 140 VAC)
220 - 240VAC
(Range 198 - 264VAC)
Power 50/60 Hz ± 2%
frequency:
Note
If the power supply is unstable, use a voltage regulator.
The maximum power consumption of the device is 1500W.
Check that there is suffi cient voltage capacity.
Operations cannot be assured if using an uninterruptible
power supply (UPS) or inverter. Do not use an
uninterruptible power supply or inverter.
- 50 -

Connecting Power Cables

1
Check that the device power supply is
turned OFF.
The device is OFF when the main power
switch is in the (O) position.
2
Secure insert the enclosed power cable
into the device power connector.
Power cable
3
Insert the power plug into the power
outlet.
Turning ON/OFF the Power
Turning ON the Power
Supply
Note
For the CS5000 model, do not turn ON the power supply
before the Spot Color kit has been set.
1
Turn ON (I) the main power switch.
2
Press and hold the power switch for
approx. 1s.
When the power supply is ON, the LED
lamp for the power switch will turn ON.
Memo
The "Intec" logo screen will be displayed in the liquid
crystal display of the control panel when the device starts.
Wait a moment until the standby screen is displayed, and
the printing is enabled.
When the power supply is turned ON for the fi rst time, the
device auto initialization will start. Wait until the standby
screen is displayed in the liquid crystal display on the
control panel.
- 51 -
1
2
ON
3
4