Network Interface Specifications; Usb Interface Specifications - Intec CS4000 User Manual

Specifi cations
Network interface specifi cations
 Basic specifi cations
1
Network protocols
 For TCP/IP
 For EtherTalk
 Connectors
1000BASE-T / 100 BASE-TX / 10 BASE-T (Auto switching and simultaneous use are not possible)
2
Note
 The default factory setting is to disable 1000BASE-T.
If using with 1000BASE-T, use the control panel to make the following settings.
Set to [Administrator menu]> [Enter password> [Network Setup]> Gigabit Network]> [Enable].
 Cables
Unshielded twist pair cable with EJ-45 connector (category 5e or later)
3
 Connector pin array
4
 Interface signals
Pin Signal Function
No. name
1 TRD+(0) Data 0 sending and receiving (+)
2 TRD-(0) Data 0 sending and receiving (-)
3 TRD+(1) Data 1 sending and receiving (+)
4 TRD+(2) Data 2 sending and receiving (+)
5 TRD-(2) Data 2 sending and receiving (-)
6 TRD-(1) Data 1 sending and receiving (-)
7 TRD+(3) Data 3 sending and receiving (+)
8 TRD-(3) Data 3 sending and receiving (-)
- 132 -
USB interface specifi cations
 Basic specifi cations
USB (supports Hi-Speed USB)
 Connectors
B receptacle (female) upstream port
 Cables
5m max. USB2.0 specifi cations cable (2m max. recommended)
(Do not use shielded cable wires.)
 Send mode
Full speed (12Mbps±0.25% max.)
High speed (480Mbps±0.05% max.)
 Power control
Self-powered device
 Connector pin array
 Interface signals
Signal Function
name
1 Vbus Power supply
(+5V)
2 D- For data transfer
3 D+ For data transfer
4 GND Signal ground
Shell Shield
- 133 -
Specifi cations
1
2
3
4