HMS Anybus Edge Reference Manual page 73

Settings
• RPC server not initialised
An RPC request was received from the portal, but the device is not an RPC server.
• Could not parse RPC: Out of memory
An out-of-memory condition occurred while parsing an RPC request or response received
from the portal.
• Could not parse RPC: <error message>
The indicated error occurred while parsing an RPC request or response received from the
portal.
• Could not process RPC: Queue is full
An RPC request or response received from the portal could not be processed, because the
RPC queue was full.
• Could not process RPC: Receive error
A receive error occurred while receiving an RPC request or response from the portal.
• Could not process RPC: Unexpected error <error code>
An unexpected error occurred while processing an RPC request or response from the portal.
The indicated error code is a Kolibri library error code.
• Ack with sequence number <sequence number> contained additional payload data
An Ack reply with the indicated sequence number received from the portal contained more
payload data than expected.
• Could not log in: Access denied
Access was refused while logging in to the portal. You should check user name and
password.
• Could not log in: Unexpected error (<error code>)
An unexpected error occurred while logging in to the portal. The indicated error code is a
Kolibri library error code.
• Could not get publish hash: Unexpected error (<error code>)
An unexpected error occurred while synchronising published nodes with the portal.
• Could not enable publishing of all active points: Unexpected error (<error code>)
An unexpected error occurred while synchronising published nodes with the portal.
• Node manipulation command failed (<error code>)
An error occurred while creating, modifying, deleting a node, getting a node's properties or
getting a list of all nodes. The indicated error code is a Kolibri library error code.
• Write command with sequence number <sequence number> failed (<error code>, <point
index>)
The write command with the indicated sequence number was not accepted by the portal.
The indicated error code is a Kolibri library error code. The indicated point index announces
the point that caused the problem.
• Write command with sequence number <sequence number> failed (<error code>)
The write command with the indicated sequence number was not accepted by the portal.
The indicated error code is a Kolibri library error code.
Anybus Edge Gateway Reference Guide
71 (148)
SCM-1202-154 1.0 en-US