HMS Anybus Edge Reference Manual page 103

Settings
• PROFINET IO module detected
An Anybus CompactCom module of PROFINET IO type has been detected.
• Advanced settings activated
The Advanced settings are active.
• Resetting Anybus CompactCom module
The Anybus CompactCom module will be reset - either due to an error or due to a request
from the network.
• IP configured
An IP address was assigned to the Anybus CompactCom module.
• DHCP client was (activated or deactivated)
The Anybus CompactCom module's DHCP client was activated or deactivated from an
external tool.
• Received illegal floating point value
An illegal floating point value has been received from the network.
• Anybus CompactCom base driver error. (Error code <error code>, Info <information code>)
An error occurred in the base driver for the Anybus CompactCom module. This should not
happen. Please contact the customer support.
• Connection to Anybus CompactCom module lost
There was a communication error between the main processor and the Anybus
CompactCom module.
• Connection to Anybus CompactCom module reestablished
After a communication error between the main processor and the Anybus CompactCom
module the communication was reestablished successfully.
• IO connection with IO controller closed
The IO connection with the IO controller has been closed.
• IO controller in STOP mode
The IO controller with which an IO connection is established is in STOP mode or the IO
controller has not provided valid output at least once.
• IO connection with IO controller established
The IO connection with the IO controller has been established and valid output data has
been provided at least once.
• Configuration data mismatch
There is a mismatch between the I/O data configuration expected by the IO controller and
the actual I/O data configuration of the Edge gateway device.
• Unexpected state: <state>
The state machine of the base driver for the Anybus CompactCom module has reached the
indicated unexpected state. This should not happen. Please contact the customer support.
• Could not set DHCP
The DHCP option could not be written into the Anybus CompactCom module. This should
not happen. Please contact the customer support.
Anybus Edge Gateway Reference Guide
101 (148)
SCM-1202-154 1.0 en-US