HMS Anybus Edge Reference Manual page 37

Settings
– Could not log in: Unexpected error (<error code)
– Could not get publish hash: Unexpected error (<error code)
– Could not enable publishing of all active points: Unexpected error (<error code)
– Node manipulation command failed (<error code)
– Write command with sequence number <sequence numberfailed (<error code, <point
index)
– Write command with sequence number <sequence numberfailed (<error code)
– Nak with sequence number <sequence numbercontained invalid payload data (<error
code)
– Could not synchronise clock: Receive error (<error code)
– Could not synchronise clock: Get time response contained invalid payload data
– Could not synchronise clock: Unexpected error (<error code)
– Could not get publish hash: Receive error
– Could not get publish hash: Out of memory
– Could not get publish hash: Unexpected error (<error code)
– Could not publish group: Invalid index <group index
– Could not publish group: Re-publish <known pathwith path <new path
– Could not publish group: Initial publish without path
– Could not publish point: Invalid index <point index
– Could not publish point: Invalid trigger mode <trigger mode
– Could not publish point: Invalid trigger mode <trigger modefor data type <data type
– Could not publish point: Invalid QoS %u
– Could not publish point: Re-publish <known pathwith path <new path
– Could not publish point: Initial publish for <path(uncertain) without path
– Could not publish point: Initial publish without path
– Could not process publish command: Invalid library state
– Publishing of groups not enabled
– Could not publish point: Invalid data type <data type
– Could not process publish command: Receive error
– Could not process publish command: Send error
– Could not process publish command: Unexpected error (<error code)
– Could not send Nak for publish command
– Could not process un-publish command: Invalid library state
– Could not un-publish <path: Invalid index
– Could not process un-publish command: Receive error
– Could not process un-publish command: Send error
– Could not process un-publish command: Unexpected error (<error code)
– Could not send Nak for un-publish command
– Could not process (committed) write command: Library not ready
Anybus Edge Gateway Reference Guide
35 (148)
SCM-1202-154 1.0 en-US