Siemens Synova FC330A Manual page 79

horn on INTERNAL ALARM:
> selected #, change?
horn on INTERNAL ALARM:
> #, ch.? 2. pulsating
horn on INTERNAL ALARM / phase ACTIVE:
(3..20sec) sel. ##/10 sec
horn on INTERNAL ALARM / phase INACTIVE:
(3..20sec) sel. ##/10 sec
al.cont. on INTERNAL ALARM:
> selected #, change?
DUAL mode:
> selected #, change?
LED ISOLATION on mode 'manned': 1. OFF
> selected #, change?
ý Description alarm organization see page 107/108
Building Technologies
Fire Safety & Security Products
− to define that the control lines 'horn' are also
1. inactive
activated during state 'internal alarm'
2. active
− applies for all 'horn' control lines
− common for all 'horn' control lines on internal
1.continuous
alarm
3.set pulse
− to set the pulse length of phase ACTIVE
change?
− to set the pulse length of phase INACTIVE
change?
− to define that all alarm contacts
1. inactive
(K3X020/K3G050) are also activated on IN-
2. active
TERNAL ALARM
− to trigger immediately the remote transmission
1. inactive
on alarm of 2 detector zones simulta-
2. active
neously during mode 'manned'
− to define whether LED 'ISOLATION' on the
front is activated upon mode 'manned' (re-
2. ON
quirement by EN54 = ON)
1. horns not activated on 'inter-
nal alarm'
2. horns activated on 'internal
alarm'
1. continuous signal on alarm
2. pulsating signal on alarm
3. goes to sub-menu 'pulse
length'
− value 3 = 0.3sec / 20 = 2sec
− one step = 0.1sec)
− default = 5 (0.5sec)
− value 3 = 0.3sec / 20 = 2sec
− one step = 0.1sec)
− default = 5 (0.5sec)
1. not activated on internal
alarm
2. activated on internal alarm
1. 'DUAL alarm' not activated
2. 'DUAL alarm' activated
1. not activated on mode
'manned'
2. activated on mode 'manned'
1583_o_en_−−_5
08.2005
75