Siemens Synova FC330A Manual page 106

5.22 How editing is basically done
Available characters: Use keys «0» to «9» of the keypad
Procedure:
1. select digit by pressing key «0» to «9»
(enter further digits)
Terminate input:
1. press key «ok»
2. press key «ok»
3. press key «Start/Stop»
Available characters:
Procedure:
1. move the cursor to the desired character
2. press key «ok»
(enter further characters, also blanks)
Terminate input:
1. press key «0»
2. press key «ok»
3. press key «ok»
4. press key «Start/Stop»
Available words from the 'word library':
Procedure:
1. enter word number and press key «ok»
(enter further words)
Terminate input:
1. press key «ok»
2. press key «ok»
3. press key «Start/Stop»
102
Building Technologies
Fire Safety & Security Products
There are 3 ways to enter charcters in order to create user text.
The LCD always serves as monitor.
select NUMBER, LETTER, WORD: (0, F1, F2)
a) NUMBER
To indicate the room or floor number etc.
ý digit 0...9 can be entered directly by the keypad
b) LETTER
To compose words.
ý selectable from a 'letter bar' shown in the LCD by moving the cursor to the desired
character
c) WORD
The most frequent words can be selected from an internal word list (library).
ý selectable by entering the corresponding word number, listed in this document
A character or word is always inserted at the current cursor position. Therefore, always
move the cursor
(see page 103)
'0', 'F1' or F2 is selected.
ý Enter 'NUMBER'
ý Enter 'LETTER'
ABCDEFGHIJKLMNOPQRSTUVWXYZ ,.;:+−()=/'
abcdefghijklmnopqrstuvwxyz ,.;:+−()=/'
ý Enter 'WORD'
where a number, letter or word has to be inserted before key
é press key «0»
digit is inserted within text line
if wrong input é press key «ok» and delete character(s)
cursor jumps to the end of the line
entry is terminated within this text block
text is saved
é press key «F1»
cursor
character 'underline' indicates position
character is inserted within text line
if wrong input é press key «0» then «ok»and delete character(s)
cursor jumps to the left upper corner
cursor jumps to the end of the text line
entry is terminated within this text block
text is saved
é press key «F2»
see page 104
word is inserted within text line
if wrong input é press key «ok» and delete word
cursor jumps to the end of the text line
entry is terminated within this text block
text is saved
«0» to enter a number
«F1» to enter a letter
«F2» to enter a word
key «F2» é lower case letters
key «F1» é upper case letters
1583_o_en_−−_5
08.2005