Siemens Synova FC330A Manual page 100

5.16.2 Function
Submenu
CONFIGURATION
(c)
− checks line configuration on completness of linking and allowed parameters
− always use this function before exit programming mode
5.16.3 Function
Submenu
CONFIGURATION
(c)
− deletes physical structure (detector types, line types), logical structure (detector zone and control zone
programming, user texts, all link information)
− the general functions (page 72....74) remain
5.16.4 Function
Submenu
CONFIGURATION
(c)
− reads actual line configuration as installed and links each device to a separate zone (same function as
selectable after system startup, see page 53)
96
Building Technologies
Fire Safety & Security Products
6. CHECK configuration
4. addressable line
1. line
2. device
3. zone
4. element
5. line 'collective'
6. CHECK configuration
7. CLEAR configuration
8. AUTOM. configuration
9. CONFIG ConTrol−ZONES
7. CLEAR configuration
4. addressable line
1. line
2. device
3. zone
4. element
5. line 'collective'
6. CHECK configuration
7. CLEAR configuration
8. AUTOM. configuration
9. CONFIG ConTrol−ZONES
8. AUTOM. configuration
4. addressable line
1. line
2. device
3. zone
4. element
5. line 'collective'
6. CHECK configuration
7. CLEAR configuration
8. AUTOM. configuration
9. CONFIG ConTrol−ZONES
ê
to define line type, number of devices, link devices
ê
to define device parameters
ê
to define zone parameters
ê
to define element parameters
ê
to link conventional lines to zone (if available)
ê
to check configuration before exit the programming mode
ê
to delete all user data
ê
to read actual line configuration as installed
ê
to define control outputs
ê
to define line type, number of devices, link devices
ê
to define device parameters
ê
to define zone parameters
ê
to define element parameters
ê
to link conventional lines to zone (if available)
ê
to check configuration before exit the programming mode
ê
to delete all user data
ê
to read actual line configuration as installed
ê
to define control outputs
ê
to define line type, number of devices, link devices
ê
to define device parameters
ê
to define zone parameters
ê
to define element parameters
ê
to link conventional lines to zone (if available)
ê
to check configuration before exit the programming mode
ê
to delete all user data
ê
to read actual line configuration as installed
ê
to define control outputs
1583_o_en_−−_5
08.2005