Figure 6.2 Default Configuration For Steering Wheel Switches Wired To Control Pad; Figure 6.3 Led Programming Indicators On The Control Pad - Federal Signal Corporation Smart Siren Installation And Maintenance Manual

Figure 6.2 Default configuration for steering wheel switches wired to control pad

The control pad legends in the illustration are for a typical configuration. The PA300-CN siren amplifier system
includes additional legends. All buttons are programmable. For instructions for programming the control pad,
see the "Control Pad Software Configuration Manual" (doc. no. 2562620).
Red Button LEDs: All buttons on the
control pad glow when the system is
on. Pressed buttons blink to indicate
that the function they control is active.
SLIDE SWITCH 1
SLIDE SWITCH 2

Figure 6.3 LED programming indicators on the control pad

LRCO WARN
STBY RADIO PA
SLIDE SWITCH LEDs: LEDs above the slide switch
glow when the system is on (1=green, 2=amber, 3=red).
The LED brightens above the position in which the slide
switch is placed.
PA300-CN Siren Amplifier
SLIDE SWITCH 3
1 3
AUX AUX
2 4 BUTTON 2
Amber LEDs: The eight LEDs mimic these
active SignalMaster patterns: Left, Right, Center-
Out, or Warn patterns 1 to 4. They also indicate
when a programmed feature of the key pad is
active (see "Setting Control Pad Options" on
page 38.)
WAIL YELP PRTY
CORNER
LEFT TAKE RIGHT
ALLEY DOWN ALLEY
Chapter 6: Setting Control Pad Options
REAR
CUT
MAN A/H
HAZARD
GUN
TRUNK
LOCK
41