Connecting Ignition Power To The Control Pad; Figure 3.11 Active-Low Input Connections; Figure 3.12 Network Power Jumper "Off" Setting - Federal Signal Corporation Smart Siren Installation And Maintenance Manual

Connecting Ignition Power to the Control Pad

To connect the control pad to ignition power:
1.
See Figure 3.11. Leave the NETWORK jumper in the default OFF position.
"OFF" JUMPER NETWORK
SETTING IS WHITE

Figure 3.11 Active-low input connections

22 AWG

Figure 3.12 Network power jumper "OFF" setting

J7
ON PIN BASE.
LEAVE JUMPER
IN OFF POSITION.
J8
PA300-CN Siren Amplifier
Chapter 3: Connecting the PA300-CN System
CABLE ASSY.
P/N 17500063
GRAY 1
PURPLE 2
WHITE/YELLOW 3
BLUE 4
J9
+ −
INPUT 1 THROUGH 4
GROUND ACTIVE
(ACTIVE LOW)
−GND
290A839
25