Figure 3.3 Serial Port Locations On Pa300-Cn And Connected Devices - Federal Signal Corporation Smart Siren Installation And Maintenance Manual

ILS System lightbars that include three models of single-level LED lightbars—Front ILS, Rear
◆
Lower ILS, and Rear Upper ILS—that mount on the inside of a vehicle windshield. Configurable
options include flash patterns and functions, such as dimming, takedown lights, and alley lights.
Figure 3.3 shows the three network serial connections on the back of the siren amplifier. Any one of the
connectors must be used for the control pad. For mounting instructions for the serial network devices,
refer to the instructions included with the products.
To connect serial devices to the Convergence Network ports:
1.
Carefully route the cables from the network devices through the vehicle to the connectors on the
siren amplifier/relay module.
2. To provide strain relief, secure the cables with installer-supplied clamps and hold-downs.
3.
Insert the modular connector at the end of each cable into the any of the three connectors.

Figure 3.3 Serial port locations on PA300-CN and connected devices

LIGHTBAR
290A6783
PA300-CN Siren Amplifier
Chapter 3: Connecting the PA300-CN System
CONTROL PAD
FS CONVERGENCE
NETWORK
CONNECTIONS:
(Select up to two serially
controlled devices plus
the control pad.)
17