Entering Program Mode; Turning Off Or On The 10-Second Notification Beep; Dimming Or Turning Off The Button Leds; Resetting To The Factory Default Configuration - Federal Signal Corporation Smart Siren Installation And Maintenance Manual

Entering Program Mode

See Figure 6.1. To set the keypad options, first enter Program Mode:
1. Press and hold Button 6 while powering up the control pad.
2. During the long beep, release Button 6. The control pad beeps continuously.
3. Verify that the first amber LED is on.

Turning Off or On the 10-Second Notification Beep

To turn the beep off or on:
1. While in Program Mode, press Button 12.
2. To continue, select another setting to change or press Button 13 to exit Program Mode. Verify that the
last amber LED turns on when you exit.

Dimming or Turning Off the Button LEDs

To dim or turn off the button LEDs:
1. While in Program Mode, press Button 8 up to four times to step though decreasing levels of brightness.
To turn off the LEDs, press Button 8 a fifth time.
2. To continue, select another setting or press Button 13 to exit Program Mode. Verify that the last amber
LED turns on when you exit.

Resetting to the Factory Default Configuration

To reset the operation and control of network devices to the factory default:
1. While in Program Mode, press Button 7.
2. To continue, select another setting to change or press Button 13 to exit Program Mode. Verify that the
last amber LED turns on when you exit.

Exiting Program Mode

To exit Program Mode
1. Press Button 13.
2.
Verify that the last amber LED turns on when you exit.
PA300-CN Siren Amplifier
Chapter 6: Setting Control Pad Options
39