System Repair; Disposal - Kollmorgen SERVOSTAR 300 Instruction Manual

S300 Instructions Manual | 4 Product life cycle handling

4.8 System Repair

Only professional staff who are qualified in electrical engineering are allowed to exchange
parts of the drive system.
CAUTION
tiple episodes may occur.
Exchange of the device
Only the manufacturer can repair the device. Opening the device voids the warranty.
1. Decommission the device (see chapter 4.5 "Decommissioning").
2. Demount the device (see chapter 4.7 "Disassembly").
3. Send the device to the manufacturer.
4. Install a new device as described in this manual.
5. Setup the system as described in this manual.
Exchange of other drive system parts
If parts of the drive system ( for example cables) must be replaced, proceed as follows:
1. Decommission the device (see chapter 4.5 "Decommissioning").
2. Exchange the parts.
3. Check all connections for correct fastening.
4. Setup the system as described in this manual.

4.9 Disposal

To dispose the unit properly, contact a certified electronic scrap disposal merchant.
In accordance with the WEEE-2012/19/EU guideline and similar, the manufacturer accepts
returns of old devices and accessories for professional disposal. Transport costs are the
responsibility of the sender.
Contact Kollmorgen and clarify the logistics.
18 Kollmorgen | kdn.kollmorgen.com | May 2020
: Automatic Start! During replacement work a combination of hazards and mul-
Work on the electrical installation may only be performed by trained and qualified per-
sonnel, in compliance with the regulations for safety at work, and only with use of pre-
scribed personal safety equipment.