Dräger Narkomed 2C Technical & Service Manual page 215

NM2C
7.6.4 Save/Restore Settings
This screen allows serial port configuration and templates to be copied to
the ORDM disk drive, or to the external PC disk drive. These settings can
then be restored from the disk to the machine following any hardware
replacement.
-- At the Primary Service Menu (described earlier) set the cursor to
SAVE/RESTORE SETTINGS and press ENTER.
-- Move the cursor with the up or down keys to the desired function and
press ENTER.
Press arrow keys to change menu items, return to activate sub-screen
MACHINE ID: NM2C
SERIAL NUMBER: 00011066
Figure 7-7: SAVE/RESTORE SETTINGS SCREEN
-- Press ESC on the ORDM (F10 on the external PC) to return to the
Primary Service Menu. If desired, press ESC (or F10) again to return to
the SST Main Menu.
Rev. G
RETURN TO THIS MANUAL'S TABLE OF CONTENTS
RETURN TO CD-ROM TABLE OF CONTENTS
SOFTWARE UPDATE PROCEDURE (continued)
SOFTWARE VERSION: 1.20
SYSTEM FEATURES: 0003
Save Serial Ports
Restore Serial Ports
F10 PREVIOUS MENU
7-11
SV50121