Dräger Narkomed 2C Technical & Service Manual page 205

NM2C
7.0 SOFTWARE UPDATE PROCEDURE
This section outlines several software installation methods, and also describes the
operation of the Service Software Toolkit (SST).
The Service Software Toolkit (SST) allows all service constants, configurations, logs and
templates to be saved to a disk for later viewing or adding to a service report. These
same constants can be reloaded after a processor has been replaced. The SST can also
be used to install Narkomed 2C software. Actual servicing of the machine is performed
manually without the use of SST.
Software updates to the Narkomed 2C anesthesia system, including communication
protocols for external monitors are done through a serial port connection to an external
PC or through the O.R. Data Manager (ORDM). The software can be downloaded to the
PC via modem, or furnished on a floppy disk.
Following is a summary of the software installation methods described in this section:
-- From an external PC using the batch file LOADNM2C.BAT. Initial installation
will install the SpaceLabs Datalogger, Marquette Tram Net, Datex AS3, and
Criticare POET IQ protocols.
-- From the ORDM. Initial installation will install the SpaceLabs Datalogger,
Marquette Tram Net, Datex AS3, and Criticare POET IQ protocols.
-- From an external PC using the SST. Any desired protocols may be selected.
-- From the ORDM using the SST. Any desired protocols may be selected.
Rev. G
RETURN TO THIS MANUAL'S TABLE OF CONTENTS
RETURN TO CD-ROM TABLE OF CONTENTS
SOFTWARE UPDATE PROCEDURE
7-1