Tool Adjustments; Adjustments - Sacmi BTA 900 Instruction Manual

166.07
.A02

ADJUSTMENTS

7
7.4

TOOL ADJUSTMENTS

7.4.1 ADJUSTMENTS
7.4.1.1 Adjusting the fixed scoring tools
(see figure 7.4.1.1)
The fixed scoring tools (1) should protrude approximately 0.17 - 0.20 mm (for aluminum caps) in relation to the die (2).
- Mount the die (2) on a tool holder (3) (supplied with the machine). Install the assembly on a suitable rotary table.
- Turn the holder and the tools and read the value given on the comparator (4).
- If the value does not correspond to that previously measured, remove the bracket (5) that secures the scorer and
then shim the tool with shims (6). Repeat until the indicated value is reached.
- Secure the scorer (1) by tightening the bracket (5).
- Repeat the operation with all the tools.
7.4.1.2 Adjusting the movable tools
For information regarding adjustments of the movable tools, see paragraph 7.5, SPINDLE ADJUSTMENT.
Figure 7.4.1.1- ADJUSTING THE FIXED SCORING TOOLS
1 Fixed scoring tools
2 Die
3 Tool holder
4 Comparator
5 Bracket
6 Shims
5
T0138
7 - 8
Revision 00 Date 18.10.1998
4
1
6
2
5
1
3
2
T0137