Switchboard - Sacmi BTA 900 Instruction Manual

166.07
.A02
USE OF THE MACHINE
6
6.1.1

SWITCHBOARD

(References in figures 6.1 and 6.1.1)
The switchboard includes a power section that contains all the parts used to drive the utilities (contactors, relays, etc.)
and a logic section with the devices that process the signals transmitted from the keyboard and controls located on the
machine.
A control keyboard, found on the logic section, is used by the operator to run and monitor the machine. A programmable
logic controller is used and the work-cycle can be set from the keyboard. Fault messages and the most significant stages
of the work-cycle are shown on the display.
WARNING!
E0004P
Button SB31, which enables operation, must be pressed whenever the start button is pressed.
All the information concerning use of the switchboard is given in the Instructions B Manual,
Use of the Microprocessor Based Control System.
TOP DISPLAY
(See figure 6.1.1)
The top display (3) is provided in a number of versions, depending on the type of caps handled.
AP2 Temperature control, Tool heating (optional)
AP3 Temperature control, Tool cooling (optional)
PC1 Electronic counter for exiting caps (detected by SQ11) (optional)
PC2 Electronic counter for caps rejected by FDP (only if FDP is provided)
SA1 Machine ON - OFF selector switch
SA18 Tool heating ON-OFF selector switch
SA30 LOCAL - OFF - REMOTE selector switch
SA40 Cap discharge control ON - OFF selector switch
SA100 MANUAL - OFF - AUTOMATIC mode selector switch
SB6A Motor M6 stop button (manual mode)
SB6M Motor M6 start button (manual mode)
SB7 Motor M7 start / stop button (manual mode)
SB8A Motor M8 stop button (manual mode)
SB8M Motor M8 start button (manual mode)
SB11 Motor M11 start / stop button (manual mode)
SB22 Motor M22 start / stop button (manual mode)
SB30A Automatic cycle stop button (machine in local)
SB30M Automatic cycle start button (effective with machine in automatic and local, button SB31 must be pressed at
the same time)
SB31 Keyboard enable button
SB33A Motor M33 stop button (manual mode)
SB33M Motor M33 start button (manual mode)
SB100 Emergency stop button on switchboard
SB101 Reset button (shutdown conditions)
SB102 Reset button PC1 (only with cap counter)
SB103 Button for changing boxes (only with cap counter)
6 - 2
Revision 00 Date 18.10.1998