Intended, Prohibited And Misuse Of The Machine - Sacmi BTA 900 Instruction Manual

Knurling machine for aluminum caps, cutting machine for plastic caps
Table of Contents

Advertisement

166.07
.A02
MAIN FEATURES
2
2.1.2

INTENDED, PROHIBITED AND MISUSE OF THE MACHINE

INTENDED USE OF THE MACHINE
The machine is specially engineered and constructed to produce products that have the characteristics indicated in
the specifications.
Safe machine operation is ensured only if the following conditions are satisfied:
- the machine is used under the required conditions and within the set limits stated in this paragraph;
- maintenance is regularly carried out as specified in chapter 8 - MAINTENANCE;
- the machine is used correctly as instructed in chapter 6 - USE OF THE MACHINE.
WARNING!
E0004P
If the machine is remote operated the user must see that the required signs are put up and in sight while the
machine is running.
The machine can be run solely in the following two modes:
- manual
- automatic
To select the required mode of operation use the mode selector on the control panel.
UNINTENDED AND PROHIBITED OPERATIONS
The machine must be used only for the tasks it was expressly designed for unless otherwise authorized by the
Manufacturer. The Manufacturer will not be held responsible for any injury to persons or damage to the machine
caused by failure to observe this safety precaution.
MISUSE OR ERRONEOUS USE
The manufacturer shall not be held responsible for any injury to persons or damage to the machine deriving from
incorrect and erroneous use of the machine. Generally speaking, the most common causes of incorrect use are listed
below:
- personnel not adequately trained to perform the required operations
- fatigue (above all during the night shift) or distraction
- negligence caused by superficiality or wrong habits.
Remember that the machine is to be controlled and run exclusively by expert well trained personnel who are able to:
- correctly operate the machine under normal conditions
- and face any emergencies.
2 - 16
Revision 00 Date 18.10.1998

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents