Dismantling - Sacmi BTA 900 Instruction Manual

166.07
.A02
Revision 00 Date 18.10.1998

DISMANTLING

9
9 DISMANTLING
WHAT TO DO WHEN THE MACHINE IS NO LONGER USED
When the machine is no longer going to be used, it should be made inoperative by following the instructions given
below:
- Cut off the power supply to the machine by using the factory's main switch
- Unplug the power cable attached to the terminal block of the electric cabinet
- Unplug the cables between the cabinet and the machine, disconnecting the connectors
- Remove the compressed air connection between the power unit and the mains
- Disconnect the cooling system from the water mains and factory drain line
- Thoroughly clean the entire machine especially the moving parts, lubricate the parts to protect them
- Close the doors of the switchboard and machine to prevent them from being tampered with, dust from
depositing, etc.
- Use any safety devices provided.
DISMANTLING
Remove the various parts of the machine observing all the safety precautions in force and following the instructions
given in chapter 4, INSTALLATION. Pay close attention to the safety precautions and warnings concerning lifting and
placing the machine given in paragraph 3.3, SAFETY RULES FOR HANDLING.
9 - 1