Basler DGC-2020ES Configuration Instruction Manual page 47

9469200995
ECU Related Time Values - Engine Shut Down
Set this parameter for a value longer than the duration required to stop the engine after being shut down.
The ECU is pulsed after this time expires. If the time is too short, the pulse may occur while the engine is
still turning which could cause a brief re-start and possibly damage the flywheel and starter system.
ECU Related Time Values - Pulse Cycle Time
Set this parameter for the desired time between ECU pulse cycles.
ECU Related Time Values - Settling Time
This parameter is the duration of the "on line" time of the pulse cycle during which the DGC-2020ES
reads data from the ECU. The settling time should be set long enough so that any ECU parameters that
require time to "settle down" after the ECU is on line can do so. Since the DGC-2020ES may use some of
the ECU data for alarm or pre-alarm annunciation, it is important that the data have time to settle.
ECU Related Time Values - Response Timeout
This setting defines the amount of time that the DGC-2020ES will wait to receive data from the ECU
during a pulse cycle or start attempt. If no data is received during this time in a pulse cycle, a LOSS OF
ECU COMMS pre-alarm is annunciated. If no data is received in this time during an engine starting
attempt, a LOSS OF ECU COMMS alarm is annunciated.
Figure 4-1. Settings Explorer, Communications, CAN Bus, CAN Bus Setup
ECU Setup
The following paragraphs describe the settings on the ECU Setup screen. This screen is found in the
BESTCOMSPlus Settings Explorer, under the Communications, CAN Bus category. If using the front
panel, navigate to Settings > Communications > CAN Bus Setup > ECU Setup. Refer to Figure 4-2.
ECU Type
The DGC-2020ES can be configured for Standard, Volvo Penta, MTU MDEC, MTU ADEC, MTU
ECU7/ECU8, GM/Doosan, Cummins, MTU Smart Connect, Scania, or John Deere.
DGC-2020ES
4-7
Communication