Basler DGC-2020ES Configuration Instruction Manual page 130

13-30
Name
STARTDELBYP
STARTOUTPUT
TESTINHIBIT
Logic Schemes
A logic scheme is a group of logic variables written in equation form that defines the operation of a DGC-
2020ES Digital Genset Controller. Each logic scheme is given a unique name. This gives you the ability
to select a specific scheme and be confident that the selected scheme is in operation. One logic scheme
is configured for typical control applications and is the default active logic scheme. Only one logic scheme
can be active at a given time. In most applications, preprogrammed logic schemes eliminate the need for
custom programming. Preprogrammed logic schemes may provide more inputs, outputs, or features than
are needed for a particular application. This is because a preprogrammed scheme is designed for a large
number of applications with no special programming required. Unneeded logic block outputs may be left
open to disable a function or a function block can be disabled through operating settings.
When a custom logic scheme is required, programming time is reduced by modifying the default logic
scheme.
The Active Logic Scheme
Digital Genset Controllers must have an active logic scheme in order to function. All Basler Electric DGC-
2020ES units are delivered with a default, active logic scheme pre-loaded in memory. If the function block
configuration and output logic of the default logic scheme meets the requirements of your application,
then only the operating settings (power system parameters and threshold settings) need to be adjusted
before placing the DGC-2020ES in service.
Copying and Renaming Preprogrammed Logic Schemes
Copying a saved logic scheme to the active logic and assigning a unique name is accomplished by
loading the saved logic scheme into BESTCOMSPlus and then typing over the logic scheme's name.
Changes are not activated until the new settings have been saved and uploaded to the device.
Sending and Retrieving Logic Schemes
To retrieve settings from the DGC-2020ES, it must be connected to a computer through a
communications port. Once the necessary connections are made, settings can be downloaded from the
DGC-2020ES by selecting Download Settings and Logic on the Communication pull-down menu.
BESTlogic™Plus
Description
This element allows the Pre Start state to be skipped
based on logic. For example, a start delay may not be
necessary when the engine is warm. This also allows an
external device, such as an ECU, to control the pre start
interval.
This element is used to drive the start output relay from
logic when the Start Output Relay configuration is set to
"Programmable". When the Start Output Relay
configuration is set to "Programmable", the start relay will
not close unless logic is used to drive this element. When
the Start Output Relay configuration is set to
"Predefined", the start relay is closed according to the
predefined start functionality of the DGC-2020ES. When
the "Predefined" functionality is selected, the relay will not
respond to this element.
When this logic element is true, the generator exercise
timer cannot start the generator. If the TESTINHIBIT logic
function is false during an exercise period, or transitions
from true to false at any time during an exercise period,
the DGC-2020ES will start and run the generator for the
duration of the exercise period.
9469200995
Symbol
DGC-2020ES