Basler DGC-2020ES Configuration Instruction Manual page 112

13-12
Name
Pre-Alarms
Battery Charger True when the Battery Charger Fail function is
Fail configured as a pre-alarm and the activation delay
has expired.
True when the ac power to the battery charger is off.
Battery Charger
(Battery Charger 1 shown.)
AC Off
Battery Charger True when the battery charger has detected that the
battery has failed. (Battery Charger 1 shown.)
Battery Failure
True when the battery charger has detected a J1939
Battery Charger
communications failure. (Battery Charger 1 shown.)
Comms Fail
Battery Charger True when the battery charger has failed. (Battery
Charger 1 shown.)
Fail
True when the battery charger output voltage is too
Battery Charger
high. (Battery Charger 1 shown.)
High Output
Volts
True when the battery charger has detected invalid
Battery Charger
settings. (Battery Charger 1 shown.)
Invalid Settings
Battery Charger True when the battery charger has detected that the
voltage while the engine is cranking has dipped too
Low Cranking
low. (Battery Charger 1 shown.)
Volts
True when the battery charger output voltage is too
Battery Charger
low. (Battery Charger 1 shown.)
Low Output
Volts
True when the battery charger has detected one or
Battery Charger
more charging output stages in a charger with
Single Unit Fail
multiple charging output stages has failed. (Battery
Charger 1 shown.)
Battery Charger True when the battery charger temperature is
beyond the thermal limit. (Battery Charger 1 shown.)
Thermal Limit
Battery True when the Battery Overvoltage pre-alarm
Overvoltage threshold has been exceeded.
Cannot Regen - True when the regeneration interlock has failed on a
Interlock Fail Yanmar ECU. Manual regeneration is blocked.
Cannot Regen - True when the coolant temp is low on a Yanmar
Low Coolant ECU. Manual regeneration is blocked.
Temp
Cannot Regen - True when 50 hours has not elapsed since last
Not 50 Hours regeneration on a Yanmar ECU. Manual
Since Last regeneration is blocked.
Regen
Checksum True when some of the user settings or firmware
code has been corrupted. Refer to the Reporting
Failure
and Alarms chapter for more details.
BESTlogic™Plus
Description
9469200995
Symbol
DGC-2020ES