Table of Contents
Advertisement
Set Module to Use DHCP IP Address
NOTE
When DHCP Configuration is initiated, the mA-3011 IP Address updates and the Web
Browser UI connection will be lost. Refer to section
page
1
Power on the CMP System.
2
Open a web browser window.
3
Enter the mA-3011 IP address in the browser window URL field.
4
Navigate to the mA-3011 Networking page (see
page
5
Select the module instrument slot and set the module Network Mode to DHCP.
–
6
Select DHCP Mode.
7
Select the Apply button. At user prompt, select the Apply and Reply button.
NOTE
The system will initiate an auto reboot sequence that takes approximately 10 to
15 seconds. If the system does not auto reboot within one minute, press the Power
On/Standby button and refer to the following:
•
If the Power On/Standby button turns green, the system has initiated the reboot
sequence. Wait while the system completes the power up process.
•
If the Power On/Standby button turns yellow, the system failed to initiate the power
on sequence. Press the Power On/Standby button again to initiate the power on
sequence and wait while the systems completes the power up process.
Rev. C0
April 2020
4-5.
5-5).
Module Network Mode menu: Slots section of the Network Settings Table
mA-3011 AXIe Embedded Host Module Operation Guide
Chapter 4 Operation and Control
mA-3011 Network Configuration
"Locate mA-3011 IP Address" on
"CPUC Networking Page" on
Page 4-7
Advertisement
Table of Contents
