Ap (Api Enable) Command - Digi XBee Product Manual

Returned Value (Hex) Association Indication
0x0A
0x0B
0x0C
0x0D
0x0E
0x0F
0x10
0x11
0x12
0x13
0xFF

AP (API Enable) command

AT Command: ATAP
Parameter range:0 - 2
Parameter
0
1
2
Default parameter value:0
Minimum firmware version required: v1.x80
<Serial Interfacing> The AP command is used to enable the RF module to operate using a frame-
based API instead of using the default Transparent (UART) mode.
Refer to API Operation for the XBee/XBee-PRO RF Module
(AP = 1 or 2).
XBee / XBee-PRO RF Modules 802.15.4 Product Manual
Coordinator realignment is in progress
Association request not sent
Association request timed out - no reply was received
Association request had an invalid parameter
Association request channel access failure - request was not transmitted - CCA failure
Remote Coordinator did not send an ACK after Association Request was sent
Remote Coordinator did not reply to the Association request, but an ACK was received
after sending the request
Reserved
Sync-Loss - lost synchronization with a Beaconing Coordinator
Disassociated - No longer associated to Coordinator
RF Module is attempting to associate
Configuration
Disabled (transparent operation)
API enabled
API enabled (with escaped characters)
Command descriptions for the XBee/XBee-PRO RF Module
on page 89 when API operation is enabled
60