Patriot 4420 - 2009 & Newer - Raven SmarTrax Installation Manual

Chapter 4
Power Connection
FIGURE 9.
Connect the round 3-pin power connector into the convenience power port in the left-rear corner of the cab.
9.
Note:
The seat may interfere with the connection if installed in the right power port.
Refer to the appropriate section below for additional steps to install CAN communication to the node
10.
harness.
Patriot 4420 - 2009 & Newer
CAN Connector Installed on Machine's CAN System
FIGURE 10.
Connect the CAN extension cable (P/N 115-4001-150) to the machine's existing CAN system.
1.
Note:
The CAN system is located in the fuse panel in the right-rear corner of the cab.
Route the opposite end of the cable out the fuse panel and around the back of the operator's seat to the
2.
instructional seat compartment.
Connect the CAN connector to the CAN connection on the node harness.
3.
24
Case IH Patriot 4420 (2009 & Newer), SPX 4410/4420 (2008 & Older), SPX 4260 (S/N JFG003537 & Newer) SmarTrax™ Installation Manual
CAN
Connection
Port