Raven SmarTrax Installation Manual page 16

Chapter 3
Install the flow switch (P/N 334-0003-085) on the valve mounting bracket using two 1/4" x 2" socket head
2.
cap screws (P/N 311-0050-109), two 1/4" flat washers (P/N 313-2300-009), two 1/4" split lock washers
(P/N 313-1000-016), and two 1/4"-20 hex nuts (P/N 312-1001-074).
Machine's Radar Bracket Bolts
FIGURE 4.
Remove the bolts used to secure the machine's radar bracket.
3.
Note:
The radar bracket is located beneath the cab.
Valve Mounting Bracket Installed
FIGURE 5.
Align the holes in the valve mounting bracket with the holes in the machine's radar bracket.
4.
Using the machine's bolts, secure the valve mounting bracket to the radar bracket.
5.
12
Case IH Patriot 4420 (2009 & Newer), SPX 4410/4420 (2008 & Older), SPX 4260 (S/N JFG003537 & Newer) SmarTrax™ Installation Manual
Machine's Radar Bracket
Mounting Bolts Installed
(Not Visible Behind
Radar in this Picture)