Install The Valve Harness - Raven SmarTrax Installation Manual

Install the Valve Harness

Valve Cable Routed Through Access Point
FIGURE 12.
Route the valve cable into the cab from the foam access point under the convenience tray on the right side
1.
of the seat.
Remove the vent plate behind the operator's seat.
2.
Valve Cable Connected to Node Cable
FIGURE 13.
Connect the rectangular 12-pin connector on the valve cable (P/N 115-4001-111) into the mating connection
3.
on the node cable (P/N 115-4001-125).
Manual No. 016-5032-082 Rev. A
Cab Component Installation
23