Raven SmarTrax Installation Manual page 26

Chapter 4
DGPS OUT Connected to Console Receiver Connection
FIGURE 10.
Console
Cable
Connect the DGPS OUT connector to the Viper Pro or Envizio Pro receiver connection.
7.
Node Cable Connected to the Convenience Power Port
FIGURE 11.
Connect the round 3-pin power connector of the node cable into the convenience power port on the
8.
instructional seat.
Note:
High current power, which is used to run the steering operations, should be connected to a power
source separate from logic power, which is used to facilitate processing and communication
between the node and the console.
22
SmarTrax
Power
Case IH Patriot 4430, Model Year 2012 SmarTrax™ Installation Manual
Console Receiver
Connection
DGPS Out
(Node Cable
Connection)