Raven SmarTrax Installation Manual page 25

Locate the ENABLE connector on the node harness and connect it to the foot switch cable connector.
2.
Route the node cable into the fuse box and behind the operator's seat.
3.
CAN Connector Installed on Machine's CAN System
FIGURE 8.
Connect the CAN connector to the machine's existing CAN system.
4.
Connect the DGPS connector to the GPS receiver.
5.
DGPS OUT Connector Routed Under Operator's Seat
FIGURE 9.
Route the DGPS OUT connector out the right corner of the operator's seat base and under the right arm
6.
rest.
Manual No. 016-5032-082 Rev. A
CAN
Cab Component Installation
21