Cab Component Installation; Install The Smartrax Node - Model Year 2010 & Older - Raven SmarTrax Installation Manual
Case ih stx/steiger/quadtrac (accuguide - ready) and new holland tj/t90x0/t9.xxx (intellisteer - ready)
Hide thumbs
Also See for SmarTrax:
- Calibration and operation manual (156 pages) ,
- Operation manual (73 pages) ,
- Installation manual (59 pages)
Table of Contents
Advertisement
CHAPTER
3
Install the SmarTrax Node - Model Year 2010
& Older
Locate the Case steering control system cables under the instructional seat.
1.
Case Cable Connected to the Case Interface Box
FIGURE 1.
Place the Case interface box (P/N 063-0173-038) on the floor of the instructional seat compartment.
2.
Connect the Case steering control cables to the Case interface box.
3.
Connect the round, 37-pin connector of the node harness (P/N 115-4001-092) to the 37-pin port of the Case
4.
interface box.
Manual No. 016-5032-002 Rev. C
C ab Component
C h a p t e r 3
Installation
Steering Control
Cables Installed
7
Advertisement
Table of Contents
