Connect Smartrax To An Existing Chassis Cable (If Applicable); Calibrate The Smartrax System - Raven SmarTrax Installation Manual

Chapter 3
Loop and tie-off the REMOTE SWITCH cable connection, securing it with plastic cable ties as necessary.
5.
Note:
The REMOTE SWITCH connector is not used in the SmarTrax system. Ensure the cable is
secured away from moving parts and heat sources.
Connect the ring terminals to the battery.
6.
Note:
The positive connectors are fused.
Connect SmarTrax to an Existing Chassis
Cable (If Applicable)
Note:
The Raven Cruizer II RTK console with the 115-4001-099 console cable may be plugged directly
into the node cable (P/N 115-4001-068). Any other Raven console and console cable combination
requires a chassis harness cable connection.
Note:
The SmarTrax interface tee is sold separately. Contact your local Raven dealer for ordering
information.
Locate and disconnect the connection between the Raven console cable and chassis cable on the
1.
machine's existing CAN system.
Install the SmarTrax interface tee cable (P/N 115-4001-070 or 115-4001-071) between the chassis and
2.
Raven console harness.
Connect the SmarTrax node cable (P/N 115-4001-092) to the remaining SmarTrax interface tee.
3.

Calibrate the SmarTrax System

Refer to the SmarTrax and SmartSteer Calibration & Operation Manual (P/N 016-0171-277) for instructions on
calibrating the SmarTrax system, adjusting system settings, and system operation.
16
Case IH STX/Steiger/Quadtrac & New Holland TJ/T90X0/T9.XXX - Steering Ready SmarTrax™ Installation Manual