Install The Valve Harness - Raven SmarTrax Installation Manual

Install the two ground wires on the grounding bar.
6.
Locate the fuse panel on the right side of the compartment.
7.
Remove the bolt from the machine's red battery cable.
8.
Install the two power wires from the node cable on the bolt.
9.
Note:
It may be necessary to cut the ring terminals from the power wires and crimp new ring terminals
(P/N 405-0200-052 or 405-0200-053) on the end.
Reinstall the machine's red battery cable on the bolt.
10.
Reinstall the bolt in the fuse panel.
11.
Loop and tie-off the REMOTE SWITCH cable connection, securing it with plastic cable ties as necessary.
12.
Note:
The ENABLE and REMOTE SWITCH connectors are not used in the SmarTrax system. Ensure
the cables are secured away from moving parts and heat sources.

Install the Valve Harness

Valve Harness Secured to Bulkhead
FIGURE 9.
Connect the round 21-pin connector on the valve harness (P/N 115-4001-159) to the mating bulkhead
1.
connector under the machine's cab.
Route the valve harness toward the existing SmarTrax valve located under the cab near the right wheel.
2.
P/N 016-5031-008 Rev. A
Cab Component Installation
11