Chapter 3
TRANSDUCER and VALVE Connections
FIGURE 10.
Connect the TRANSDUCER connector to the pressure transducer installed in Port PS of the SmarTrax
3.
valve.
Connect the VALVE connector to the open 4-pin Deutsch port on the PVES valve.
4.
WAS Connection
FIGURE 11.
Route the WAS connectors of the valve harness toward the front axle.
5.
Disconnect the machine's existing WAS connection.
6.
Install the WAS connectors of the valve harness between the machine's WAS connectors.
7.
Use plastic cable ties to secure any excess cable away from moving parts and heat sources.
8.
12
Buhler Versatile 260/290/310 Steering Ready, Model Year 2015 & Newer SmarTrax™ Installation Manual
TRANSDUCER
Connection
(Transducer Not
Visible)
VALVE
Connection