Tilt Switch - KYMCO G-DINK 300i Service Manual

13. FUEL INJECTION SYSTEM

TILT SWITCH

INSPECTION
Support the scooter level surface.
Put the side stand up and engine stop switch
is at "RUN".
Turn the ignition switch to "OFF"
Remove the screws, washers and tilt switch.
＊
Do not disconnect the tilt switch
connector during inspection.
Place the tilt switch vertical as shown, and
turn the ignition switch to "ON".
Measure the voltage between the following
terminals of the tilt switch connector with
the connector connected.
Terminal
Violet/Red (+) – Green/Pink (-) 5 V (ECU
Black/Blue (+) – Green/Pink (-) 0.4～1.4 V
Incline the tilt switch 65±10 degrees to the
left or right with the ignition switch turned
to "ON".
Measure the voltage between the following
terminals of the tilt switch connector with
the connector connected.
Terminal
Violet/Red (+) – Green/Pink (-) 5 V (ECU
Black/Blue (+) – Green/Pink (-) 3.7～4.4 V
If repeat this test, first turn the ignition
switch to "OFF", then turn the ignition
switch to "ON".
REMOVAL/INSTALLATION
Disconnect the connector and remove two
screws.
Remove the Tilt switch.
Installation is in the reverse order of
removal.
＊
Install the tilt switch with its "UP" mark
facing up.
Tighten the mounting screws securely.
13-19
Tilt Switch
Normal
Tilt Switch
voltage)
Normal
voltage)
G-DINK 300i
"UP" Mark
Connector