KYMCO G-DINK 300i Service Manual page 96

7. CYLINDER/PISTON
CYLINDER/PISTON INSTALLATION
Remove any gasket material from the
crankcase surface.
＊
• Be careful not to drop foreign matters
into the crankcase.
Install the piston, piston pin and a new piston
pin clip.
＊
• Position the piston "IN" mark on the
intake valve side.
• Place a clean shop towel in the
crankcase to keep the piston pin clip
from falling into the crankcase.
Install the dowel pins and a new cylinder
gasket on the crankcase.
Coat the cylinder bore, piston and piston
rings with clean engine oil.
Carefully lower the cylinder over the piston
by compressing the piston rings.
＊
• Be careful not to damage or break the
piston rings.
• The piston ring end gaps should not be
parallel with or at 90° to the piston pin.
"IN" Mark
Piston Pin Clip
Dowel Pin
Cylinder
G-Dink 300i
Piston
Piston Pin
Gasket
7-8
10-8