KYMCO G-DINK 300i Service Manual page 62

4. LUBRICATION SYSTEM
ASSEMBLY
Dip all parts in clean engine oil.
Install the outer rotor into the oil pump body.
Install the inner rotor into the outer rotor.
Install the oil pump shaft.
Install the dowel pin onto the oil pump body.
Install the oil pump cover onto the oil pump
body by aligning the dowel pin.
Install and tighten the screw to the specified
torque.
Torqur: 3 N•m (0.3kgf•m, 2 lbf•ft)
INSTALLATION
Install the oil pump and tighten the two bolts
securely.
＊
Make sure the pump shaft rotates
freely and arrow on the oil pump is
id
Dowel Pin
Oil Pump Arrow Mark
G-DINK 300i
Oil Pump Cover
Oil Pump Cover
Screw
Bolts
4-8