Vsn Status Icon; Quality; Machine Speed; Camera Furrow Offset - Raven VSN Operation Manual

CHAPTER 4

VSN STATUS ICON

VSN System Status Icon Displays
TABLE 1.
Status Icon
Green System is ready for row steering operation. No active Diagnostic Trouble Codes (DTC).
Yellow Solution quality is low. No active DTCs. System may be operated with caution.
Red Active DTCs are preventing the system from operating.

QUALITY

The percentage displayed indicates the current steering solution quality.

MACHINE SPEED

Current GPS speed of the machine.

CAMERA FURROW OFFSET

Distance from the right camera to the center of the nearest furrow bottom.
• A positive value means the camera is to the right of the furrow.
• A negative value means the camera is to the left of the furrow.
The offset value may be edited after the VSN camera has been calibrated to fine tune the tire-to-furrow position
and help to center the tire in the furrow. Select the left button to nudge the tire to the left, and the right button to
nudge the tire to the right. Using these buttons will nudge the tire in ±1 inch increments.

ROW DETECTION QUALITY

Set the minimum quality value that must be met to engage VSN. This value is the cameras ability to detect the
crop rows versus the furrows. This value is editable.
A value of 50% is recommended. In Vision Only mode, VSN will disengage if the solution quality goes below the
set percentage. In Vision Plus mode, VSN will revert back to GPS guidance.

ROW SPACING

Displays the current row spacing entered for the current row spacing preset. Select the button to select a currently
calibrated row spacing preset or calibrate a new row spacing preset. Up to 5 row spacing presets may be saved.
14
Description
VSN Operation Manual