Chapter 3 Initial Calibration - Raven VSN Operation Manual

CHAPTER
3
Complete the following steps to configure the VSN system for the mounting position on a specific machine.
NOTE: For best results, take all measurements in operating conditions and measure to the nearest 1/4 inch
[nearest cm].
To reset or adjust the Machine Calibration, the VSN system must be reset to factory defaults.
1. Measure the height of the camera lens to the bottom of the furrow.
2. Use the on-screen keypad to enter the camera height.
FIGURE 1. VSN Camera Height
3. Select the Next button.
4. Next, measure and enter the distance from the rear axle of the vehicle to the camera lens.
NOTE: A positive value means the camera is located in front of the rear axle.
Initial Calibration:
I NITIAL CALIBRATION
C H A P T E R 3
7