Assembling The Xy Autosampler - Agilent Technologies XY Operator's Manual

1 Locate and remove the black plastic plug located on the right side panel of the
2 With your left hand, hold the horizontal arm into place.
3 Using a Phillips screwdriver, remove the arm locking screw, located inside the
4 Insert the arm locking screw into its storage location on the rear panel.
5 Replace the plastic plug on the side panel.
6 Ensure that the horizontal arm can move by pushing it to the left as far as it
Figure 4
arm locking screw
horizontal arm
plastic plug
Installation

Assembling the XY Autosampler

Assembling the XY Autosampler
Arm Locking Screw Removal
During shipment, a screw locks the horizontal arm into place.
XY autosampler.
XY autosampler.
will go.
Before packing the XY autosampler for shipment, always secure the
horizontal arm using the arm locking screw.
Removing the Arm-Locking Screw
Vertical Arm Installation
Before installing or changing the vertical arm, check that the power is turned
off and the power cord is disconnected from the power socket. Also ensure
19