Agilent Technologies XY Operator's Manual page 28

1 Setup your sipper system as described in the Installing and Operating Your
2 Connect the end of the sipper inlet tubing having the transparent fitting, to the
Figure 13
Installation
Assembling the XY Autosampler
Connecting the Sipper Tubing to the XY Autosampler
For a fully automated sample handling, you have to connect a flow cell with
sipper pump (part number 89052B) and tubing (part number 5042-1334) to
the XY autosampler.
Only a brief description on how to connect the inlet tubing of the flow cell to
the needle of the XY autosampler is given here. For more detailed
instructions on how to setup the sipper system, refer to the Installing and
Operating Your Sipper System manual, part number 89068-90005.
Sipper System manual.
threaded connector of the XY autosampler needle. See Figure 13.
Connecting the Sipper Tubing to the XY Autosampler
28
connector for sipper tubing