Agilent Technologies XY Operator's Manual page 25

Figure 10
1 Screw the tray spacers into place. See Figure 11.
N O T E
2 Place the tray on top of the tray spacers making sure it fits securely in the tray
Installation
Assembling the XY Autosampler
Mounting the Support Bar
Tray Installation
The tray positions the racks and any accessories that fit onto the bed of the
XY autosampler. It also contains liquid spills, such as those caused by
overflowing vessels. The tray can be installed in an upper or lower position
on the XY autosampler's bed depending on the size of tubes being used.
Upper Position
If using tubes that are less than 100 mm in height:
When not being used, screw the tray spacers into the holes located in the left
rear of the XY autosampler's bed.
mounting brackets and that the drain outlet is located at the left rear of the
tray. Attach one end of the drain tubing to the drain outlet and place the other
in a drain receptacle, located lower than the tray.
Lower Position (currently not used)
If you are using tubes that are more than 100 mm in height, install the tray in
the lower position on the tray mounting brackets. Make sure that it fits
securely and that the drain outlet is located at the left rear of the tray. Attach
25