Agilent Technologies XY Operator's Manual page 21

Figure 6
needle holder bracket
horizontal slider
needle foot
6 Use the supplied screws to secure the vertical arm to the horizontal slider. The
7 Reinsert the control rod as far as it will go. While inserting the control rod, you
8 Applying pressure at the vertical arm's base, push the vertical arm to the back
9 While slightly moving the needle holder bracket up and down, push the
10 Reinsert the white plastic plug.
11 Reattach the cover plate to the front of the horizontal arm.
Installation
Assembling the XY Autosampler
Installing the Vertical Arm—Part 2
screws insert into the bottom of the mounting holes in the horizontal slider.
You may need to move the vertical arm back and forth slightly to align its
mounting holes with those in the horizontal slider.
may need to rotate it back and forth slightly to get it to pass through the
gearing and motor drive socket in the horizontal slider.
of the horizontal arm.
control rod until it clicks into position.
21