Agilent Technologies XY Operator's Manual page 31

Figure 15
N O T E
Figure 16
male D-connector; connect
to sample changer
Installation
Setting up the Communication Interface
Rear View of XY Autosampler
Connecting RS-232 Cable
Make sure your computer is turned off before making any connections.
To connect your computer to the XY autosampler, you use the RS-232 cable
(part number 5181-1520) that comes with the system.
Attach the male end of the RS-232 cable (25 pin end) to the RS-232 port
located on the rear panel of the XY autosampler. Tighten the retaining
screws.
Attach the other end of the RS-232 cable (9 pin end) to the computer's RS-232
port. (Do not mistake it for the female 25-pin parallel printer port!) Again,
tighten the retaining screws.
RS-232 Connector Cable
Unit ID and Baud Rate Selection
Use the SWI selector to choose a different unit ID and the SW2 to choose a
different baud rate. These selectors are located on the XY autosampler's rear
panel; see Figure 21 on page 54 if necessary.
RS 232 Interface
female D-connector;
connect to computer
31